A simulation study on the mode conversion process from slow Z-mode to LO mode by the tunneling effect and variations of beaming angle

For a particular angle of incidence wave, it is possible for a slow Z-mode wave incident on an inhomogeneous plasma slab to be converted into an LO mode wave. But for another wave normal angle of the incident wave, it has been considered impossible, since an evanescence region exists between two mode branches. In this case we expect that the mode conversion takes place through the tunneling effect. We investigate the effect of the spatial scale of the density gradient on the mode conversion efficiency in an inhomogeneous plasma where the mode conversion can occur only by the tunneling effect. We use the computer simulation solving Maxwell’s equations and the motion of a cold electron fluid. By considering the steepness of the density gradient, the simulation results show the efficient mode conversion could be expected even in the case that the mismatch of the refractive indexes prevents the close coupling of plasma waves. Also, we show for these cases the beaming angle does not correspond to Jones’ formula. This effect leads to the angles larger and smaller than the angle estimated by the formula. This type of mode conversion process becomes important in a case where the different plasmas form a discontinuity at their contact boundary.     

Impact of local and global factors and meteorological parameters in temporal variation of atmospheric potential gradient

In this research work, we have performed comparative diurnal variations of atmospheric Potential Gradient (PG) of fair-weather days by using the data of three stations installed in Northern, Pakistan for the year 2018. We investigated the impact of both local and global factors and meteorological parameters in the diurnal variation of atmospheric Potential Gradient on the annual and seasonal time scale. We observed two peaks, primary and secondary. This is because of the land-based measurements of annual and seasonal variations. The annual average curve of Potential Gradient of all three stations: Islamabad (CES), Muzaffarabad (MZF), and Balakot (BKT) demonstrated a notable deviation from the standard oceanic Carnegie curve. The atmospheric Potential Gradient variations are due to numerous meteorological factors e.g., air pollution, humidity, aerosol particles, fog, and temperature. Among three stations, the MZF station is located in highland (mountainous) and it demonstrated a higher atmospheric Potential Gradient. We further differentiate the results of our three stations with global results for authenticity and observed coherence between them. In addition, a positive correlation of fair-weather Potential Gradient is observed with temperature and a notable correlation between relative humidity and atmospheric Potential Gradient for all the three observatories.     

Spatial and temporal monitoring of drought conditions using the satellite rainfall estimates and remote sensing optical and thermal measurements

Drought is an important natural disaster that causes devastating impacts on the ecosystem, livestock, environment, and society. So far, various remote-sensing methods have been developed to estimate drought conditions, each of which has advantages and restrictions. This study aims to monitor the real-time drought indices at the field scales via the integration of various earth observations. Our proposed method consists of two steps. In the first step, the relationships between long-term standardized precipitation indices (SPI) derived from PERSIANN-CDR rainfall data and two drought-dependent parameters derived from MODIS products, including normalized NDVI and soil-air temperature gradient, are obtained at the spatial resolution of PERSIANN-CDR grid (approximately 25 km). As the next step, the corresponding relationships are applied to estimate the drought index maps at the spatial resolution of MODIS products (1 km). Numerous analyses are carried out to evaluate the proposed method. The results revealed that, from various drought indices, including SPIs of different timescales (1, 3, 6, and 12-months), SPI-3 and SPI-6 are more appropriate to the proposed method in terms of correlation with temperature and vegetation parameters. The findings also demonstrate the competency of the proposed method in estimating SPI indices with average RMSE 0.67 and the average correlation coefficient of 0.74.     

Hyper Heuristic Approach for Design and Optimization of Satellite Launch Vehicle

Satellite launch vehicle lies at the cross-road of multiple challenging technologies and its design and optimization present a typical example of multidisciplinary design and optimization(MDO) process.The complexity of problem demands highly effi-cient and effective algorithm that can optimize the design.Hyper heuristic approach(HHA) based on meta-heuristics is applied to the optimization of air launched satellite launch vehicle(ASLV).A non-learning random function(NLRF) is proposed to con-trol low-level meta-heuristics(LLMHs) that increases certainty of global solution,an essential ingredient required in product conceptual design phase of aerospace systems.Comprehensive empirical study is performed to evaluate the performance advan-tages of proposed approach over popular non-gradient based optimization methods.Design of ASLV encompasses aerodynamics,propulsion,structure,stages layout,mass distribution,and trajectory modules connected by multidisciplinary feasible design approach.This approach formulates explicit system-level goals and then forwards the design optimization process entirely over to optimizer.This distinctive approach for launch vehicle system design relieves engineers from tedious,iterative task and en-ables them to improve their component level models.Mass is an impetus on vehicle performance and cost,and so it is considered as the core of vehicle design process.Therefore,gross launch mass is to be minimized in HHA.     

An iterative approach for modal analysis of solid rocket motor incorporating frequency dependent modulus

The modulus of viscoelastic materials varies with excitation frequency.However,during modal analysis of frequency dependent materials,a material evaluation frequency is necessary because stiffness cannot be modified during eigenfrequency procedure.As a result,only those vibration modes are accurate,of which eigenfrequency is close to the material evaluation frequency.In order to obtain vibration modes of solid rocket motor (SRM) using material modulus based on frequency which is the same as the eigenfrequency,an iterative approach was proposed.Results of the iterative technique show that frequency modes obtained from the method are in complete agreement with the eigenfrequency and material evaluation frequency.      

Variation of hmF2 and NmF2 deduced from DPS-4 over Multan (Pakistan) and their comparisons with IRI-2012 & IRI-2016 during the deep solar minimum between cycles 23 & 24

We report the results of ionospheric measurements from DPS-4 installed at Multan (Geog coord. 30.18°N, 71.48°E, dip 47.4°). The variations in F2-layer maximum electron density NmF2 and its peak height hmF2 are studied during the deep solar minimum between cycles 23 & 24 i.e 2008–2009 with comparisons conducted with the International Reference Ionosphere (IRI) versions 2012 & 2016. We find that the hmF2 observations peak around the pre-sunrise and sunrise hours depending on the month. Seasonally, the daytime variation of NmF2 is higher in the Equinox and Summer, while daytime hmF2 are slightly higher in the Equinox and Winter. High values of hmF2 around midnight are caused by an increase of upward drifts produced by meridional winds. The ionosphere over Multan, which lies at the verge of low and mid latitude, is affected by both $E\times B$ drifts and thermospheric winds as evident from mid-night peaks and near-sunrise dips in hmF2. The results of the comparison of the observed NmF2 and hmF2 for the year 2008–2009 with the IRI-2012 (both NmF2 and hmF2) and IRI-2016 (only hmF2) estimates indicate that for NmF2, IRI-2012 with Consultative Committee International Radio (CCIR) option produces values in better agreement with observed data. Whereas, for hmF2, IRI-2016 with both International Union of Radio Science (URSI) and CCIR SHU-2015 options, predicts well for nighttime hours throughout the year. However, the IRI-2012 with CCIR option produces better agreement with data during daytime hours. Furthermore, IRI-2012 with CCIR option gives better results during Equinox months, whereas, IRI-2016 with both URSI and CCIR SHU-2015 options predict well for Winter and Summer.     

Tropopause analysis over the Iranian region using GPS radio occultation data

Near-tropopause phenomena like upper level fronts and cyclones, penetrative cumulus convection and mesoscale mechanisms of exchange make important contributions to the mixing processes in the atmosphere. Spatio-temporal monitoring of the tropopause height, temperature and pressure is an appropriate tool to show the running processes in the atmosphere. In this study, GPS radio occultation data is used to investigate the tropopause height fluctuations and the relation between the stratosphere–troposphere exchange and the aforementioned phenomena over the Iranian region. The paper shows how the position of the sub-tropical jet has changed with time, using GPS radio occultation observations. The tropopause height changes latitudinally, and three different bimodal probability distribution functions are observed. The results also show that the mixing region in the south of Iran is associated with the subtropical jet in winter. However, this region shifts north of Iran due to changes in the position of the subtropical jet during the summer. Consistency of the mixing region from the radio occultation data and the total ozone of TOMS over the Iranian region is also observed.     

InSight Mars Lander Robotics Instrument Deployment System

The InSight Mars Lander is equipped with an Instrument Deployment System (IDS) and science payload with accompanying auxiliary peripherals mounted on the Lander. The InSight science payload includes a seismometer (SEIS) and Wind and Thermal Shield (WTS), heat flow probe (Heat Flow and Physical Properties Package, HP³) and a precision tracking system (RISE) to measure the size and state of the core, mantle and crust of Mars. The InSight flight system is a close copy of the Mars Phoenix Lander and comprises a Lander, cruise stage, heatshield and backshell. The IDS comprises an Instrument Deployment Arm (IDA), scoop, five finger “claw” grapple, motor controller, arm-mounted Instrument Deployment Camera (IDC), lander-mounted Instrument Context Camera (ICC), and control software. IDS is responsible for the first precision robotic instrument placement and release of SEIS and HP³ on a planetary surface that will enable scientists to perform the first comprehensive surface-based geophysical investigation of Mars’ interior structure. This paper describes the design and operations of the Instrument Deployment Systems (IDS), a critical subsystem of the InSight Mars Lander necessary to achieve the primary scientific goals of the mission including robotic arm geology and physical properties (soil mechanics) investigations at the Landing site. In addition, we present test results of flight IDS Verification and Validation activities including thermal characterization and InSight 2017 Assembly, Test, and Launch Operations (ATLO), Deployment Scenario Test at Lockheed Martin, Denver, where all the flight payloads were successfully deployed with a balloon gravity offload fixture to compensate for Mars to Earth gravity.     

Simultaneous spacecraft attitude and orbit estimation using magnetic field vector measurements

Based on magnetometer measurements only, three-axis attitude, rate, and orbit estimation are successfully achieved. A single Augmented Dynamics Extended Kalman Filter (ADEKF) is configured by combining the spacecraft nonlinear attitude dynamics and quaternion kinematics with orbital mechanics. The filter design is adopted for three-axis stabilized spacecraft in low Earth orbits where the aerodynamic drag is the dominant source of disturbances in addition to the spacecraft magnetic residuals. To reduce the computational burden, another Interlaced Extended Kalman Filter (IEKF) is developed to uncouple the attitude/rate from the orbit dynamics. Both filters are implemented using the magnetometer measurements and their corresponding time derivatives. As a part of EgyptSat-1 flight scenario, detumbling and standby modes are used for performance testing of the ADEKF. The concept of local observability is applied to the basic filter and the stability is investigated by incorporating extensive Monte Carlo simulations with uniformly distributed initial conditions. The filter shows the capability of estimating the attitude better than 5 deg and rate of order 0.03 deg/s in each axis. In orbit estimation, the filter is capable of estimating the position with accuracy less than 8 km and velocity upto 5 m/s in each axis.     

Security, Internet connectivity and aircraft data networks

Internet connectivity which was in experimental stages only a few years ago is a reality today. Current implementations allow passengers to access Internet for pleasure and in some cases secure VPN access is provided to corporate networks. Several researchers are looking at the possibility of the existence of a total of three networks: passenger network (PN); crew network (CRN); and the control network (CON). Researchers envision an architecture where these three networks will co-exist in an airplane. The available Internet connectivity can be utilized for transporting flight critical information like cockpit flight data recorder (CFDR) data, digital flight data recorder (DFDR) data, cockpit voice recorder (CVR) data, and controller pilot data link communication. In addition, the Internet connectivity could also be used for other safety mechanisms like video surveillance and remote control of the flight. Security is one of the major concerns that affect the successful deployment of aircraft data networks (ADN) and other safety features. Several studies have been carried out to secure the network using firewalls and intrusion detection system but so far no study has focused on securing the communication channel (between the aircraft and the ground station) and its impact on the ADN. The scope of this research is to determine the viability and need of a security mechanism. The research also focuses on the performance of different security architectures and determine their usability in the framework of an ADN.